The Bambu Lab Micro Lidar with dual red laser is the official replacement sensor module for X1 series printers, performing the first-layer inspection, automatic flow calibration, and spaghetti detection that make Bambu Lab's automated printing system so reliable. A functioning Lidar is essential for the printer's AI-driven quality monitoring to operate correctly.

This replacement unit carries the dual red laser configuration specific to X1 series machines, and is a genuine Bambu Lab OEM part for guaranteed compatibility with the X1C, X1E, and X1 mainboard and firmware. It should be installed following the official Bambu Lab maintenance guide to restore full sensor functionality after damage or degraded performance.

Key features

• Dual red laser Lidar for accurate first-layer scanning and automatic bed levelling compensation.
• Enables automatic flow rate calibration for precise extrusion control on every print job.
• Powers spaghetti detection (AI-based failure recognition) to pause and protect ongoing prints.
• Official OEM replacement part for full X1 series firmware and hardware compatibility.
• Restores all Bambu Lab AI monitoring features after sensor damage or performance degradation.
• Required for correct operation of Bambu Lab's automated calibration and quality assurance system.

Compatible with: Bambu Lab X1C, X1E, X1